New OBD protocol for Bosch MG1UA008 ECU – CF Moto.

From today, with KESS3, you can work in OBD mode on the new CF Moto UForce CF1000UTR-8, equipped with Bosch MG1UA008 ECU and 1000cc engine, produced from 2025 onwards.

Bosch EDC17CP52 – Iveco Daily 2.3 and 3.0 FPT

KESS3 now also supports the EDC17CP52, giving you full control over the entire 2.3 and 3.0 FPT range, available with the KESS3 Truck/Agri activation (for vehicles over 3.5 tonnes).

Bosch EDC17C49 – Iveco Daily 2.3 and 3.0 FPT

KESS3 expands its field of action and makes interventions on the most common work vehicles in Europe even easier.

Continental Getrag DC4 – Renault EDC

You can now operate on Continental Getrag DC4 TCUs found in Renault, directly through the diagnostic port.

New protocol for Delphi CP2.15 – Mercedes-Benz EQx

Work in BOOT mode on the new ECU for EVs, now supported

New protocol for Continental SIMOS16.x ECU – Audi 3.0 TFSI

Works in Virtual Reading OBD on Continental SIMOS16.x ECUs of Audi.

Continental SIMOS19.3 and SIMOS19.6 – VAG Group

Now available on KESS3 and Powergate: Continental SIMOS19 ECUs for reprogramming via OBD.

Continental 6R80 – Ford

With this release, you can work on Continental 6R80 TCUs installed on Ranger and Everest models from 2011 to present, via OBD.

New protocol for Bosch MG1CS036 – Ford

Work in BOOT mode on the new TCUs supported by KESS3.

ZF PDK2 – Porsche

Work in BOOT mode on the new TCUs supported by KESS3.