Notizia

dal mondo del tuning

You can now operate on Continental Getrag DC4 TCUs found in Renault, directly through the diagnostic port.
New version of Flex, version 7.35.0.0, enabling OBD programming for Bosch MD1CS025 and MD1CP006 control units installed on Ford 1.5L EcoBlue Diesel and 6.7L Power Stroke Diesel engines.
Work in BOOT mode on the new ECU for EVs, now supported
The Denso RH850 and SH7058 ECUs found in Yamaha models are now supported with VR reading via OBD, using your AT Tool.
Kawasaki is joining the race! The Denso SH7058 as well as Mitsubishi MH8115F and MH8610F ECUs are now supported with VR reading via OBD.
Version 7.34.0.0 of Flex out now, introducing OBD programming for a wide range of Bosch control units installed on Ford USA vehicles: MG1CS060, MG1CS055, MG1CS040, and MD1CP062.
Works in Virtual Reading OBD on Continental SIMOS16.x ECUs of Audi.
Autotuner motorcycle coverage keeps growing! The Denso RH850 and Mitsubishi RH850 ECUs found in Suzuki models are now supported with VR reading via OBD, using your AT Tool.
This protocol for Ford vehicles allows you to perform a real read (NR) directly through the OBD port, giving you immediate access to the ECU’s content.
With the release of Flex software version 7.33.0.0, OBD programming is now available for Bosch VD1CP110 control units, used in the management of AdBlue systems.
Now available on KESS3 and Powergate: Continental SIMOS19 ECUs for reprogramming via OBD.
Triumph remains firmly in our sights. The Keihin KHR4 and KTKSv1 ECUs now join our OBD compatibility list, supported with your AT Tool.
With this release, you can work on Continental 6R80 TCUs installed on Ranger and Everest models from 2011 to present, via OBD.
Motorcycles are back on track with support for the Keihin KTKSv2 ECU on Triumph models, via OBD, using your AT Tool.
Introducing support to Bosch MD1CS027 and MD1CP061 control units installed on Ford and Volkswagen vehicles, including those equipped with the newest tuning protection systems.
Work in BOOT mode on the new TCUs supported by KESS3.
Now you can operate via the diagnostic port on Ford vehicles with 1.5L EcoBlue diesel engines, quickly and safely, without any unlocking procedure.
Work in BOOT mode on the new TCUs supported by KESS3.
We have talked a lot about big models... but at Ford, even the smaller ones have something to say. The Bosch MD1CS025 ECU is now fully supported in OBD mode.
We have expanded the ECU coverage on diesel vehicles from the Hyundai-Kia group with R/W in BENCH mode on the Delphi DCM7.1AP, installed on 1.5 16v CRDi engines from 2017 to 2020.
The new OBD protocol has been released for managing the map area of Bosch MG1CS036 ECUs (including those equipped with the latest anti-tuning protections).
With this new protocol, KESS3 expands BENCH mode support for VAG vehicles equipped with NA 1.0 and 1.5 MPI engines from 2018/2019 onwards.
Expand your tuning possibilities on MG vehicles with 1.5 VTi-Tech engines, increasingly popular worldwide.
Access the electronic management of the latest Yamaha models equipped with the 890 cm³ CP3 engine.