New specific KESS3 DataLogger protocols dedicated to the Volkswagen Group.

The new release introduces new DataLogger protocols for Audi, Volkswagen, Seat, Skoda, Cupra, Porsche, Bentley and MAN Truck & Bus.

New OBD VR protocol for Continental EMS2207 ECU – Ford.

Thanks to OBD mode with Virtual Reading, you can work through the diagnostic port on the Continental EMS2207 ECU, installed on 2.5-litre petrol or ethanol engines from 2012, to optimize engine response and adjust power delivery.

New OBD and BENCH protocols for Transtron 6XK1 and 4JXX – Isuzu heavy-duty vehicles.

KESS3 expands its coverage of Isuzu heavy-duty vehicles, from 2006 models to the most recent applications produced after 2019.

New BENCH protocol for Continental SIMOS18.X – VAG.

Installed on 1.8 and 2.0 TSI and TFSI EA888 turbo petrol engines from 2010, Continental SIMOS18.X ECUs can now also be managed in BENCH mode, in addition to the already supported OBD and BOOT modes.

New BOOT protocol for Delphi DCM7.1P: new-generation diesel pick-ups.

BOOT mode enables full access to the Delphi DCM7.1P, installed on Fiat, Peugeot and RAM Trucks pick-ups equipped with 2.2 BlueHDi diesel engines from 2024. It operates directly on the ECU for advanced repair operations and optimization of engine management.

New BOOT protocol for Continental DC4 GEN II – Dacia, Renault and Smart.

With the new BOOT support for the Continental DC4 GEN II TCU, already available in OBD and BENCH mode, you can now access the transmission electronics directly with the highest level of operability.

New BENCH protocol for motorcycles/ATV – Delphi MT05.2.

Development dedicated to the motorcycle segment continues with the introduction of BENCH mode support for Delphi MT05.2 ECUs, installed on a wide range of models with engines from 250cc to 800cc from 2015 onwards.

New OBD protocol for Bosch MD1CS069 in the agricultural sector.

One of the most widespread platforms in the sector is now manageable directly via the diagnostic port.

With the release of the dedicated protocol for Bosch MD1CS069 ECUs, installed on 2.9, 3.4 and 3.6 Stage V engines from 2017 onwards, it is now possible to operate in OBD mode without invasive procedures on the control unit.

KESS3 introduces the BENCH protocol for Bosch MD1CS069 on Iveco Daily.

A new expansion of operational capabilities is now available with KESS3: thanks to the release of the dedicated protocol for Bosch MD1CS069 ECUs installed on Iveco LCVs, it is now possible to operate in BENCH mode, without the need for invasive operations on the control unit.

KESS3 introduces DataLogger: analyse ECU parameters during real use.

Alientech further expands the operational capabilities of KESS3 with the introduction of the new DataLogger function: the integrated feature dedicated to real-time ECU parameter monitoring and recording.