Autore: Saša

Continental Getrag DC4 – Renault EDC

You can now operate on Continental Getrag DC4 TCUs found in Renault, directly through the diagnostic port.

Flex OBD for Bosch MD1CS025 and MD1CP006

New version of Flex, version 7.35.0.0, enabling OBD programming for Bosch MD1CS025 and MD1CP006 control units installed on Ford 1.5L EcoBlue Diesel and 6.7L Power Stroke Diesel engines.

New protocol for Delphi CP2.15 – Mercedes-Benz EQx

Work in BOOT mode on the new ECU for EVs, now supported

Yamaha Denso RH850/SH7058

The Denso RH850 and SH7058 ECUs found in Yamaha models are now supported with VR reading via OBD, using your AT Tool.

Kawasaki Denso SH7058 and Mitsubishi MH8115F/MH8610F

Kawasaki is joining the race! The Denso SH7058 as well as Mitsubishi MH8115F and MH8610F ECUs are now supported with VR reading via OBD.

Bosch MDG1 for Ford USA

Version 7.34.0.0 of Flex out now, introducing OBD programming for a wide range of Bosch control units installed on Ford USA vehicles: MG1CS060, MG1CS055, MG1CS040, and MD1CP062.

New protocol for Continental SIMOS16.x ECU – Audi 3.0 TFSI

Works in Virtual Reading OBD on Continental SIMOS16.x ECUs of Audi.

Suzuki Denso/Mitsubishi RH850

Autotuner motorcycle coverage keeps growing! The Denso RH850 and Mitsubishi RH850 ECUs found in Suzuki models are now supported with VR reading via OBD, using your AT Tool.

Bosch ME17.0.3 ECUs, now supported in OBD mode for Ford vehicles

This protocol for Ford vehicles allows you to perform a real read (NR) directly through the OBD port, giving you immediate access to the ECU’s content.

Bosch VD1CP110 Exclusive OBD

With the release of Flex software version 7.33.0.0, OBD programming is now available for Bosch VD1CP110 control units, used in the management of AdBlue systems.