Saša, Author at ECU Remap Center

Bosch EDC17C49 – Iveco Daily 2.3 and 3.0 FPT

KESS3 expands its field of action and makes interventions on the most common work vehicles in Europe even easier.

Bosch MDG1 DDE8/DME8 2020+

Things are getting serious for Bosch MDG1 ECUs fitted from 2020 onwards across BMW platforms! The DDE8 and DME8 versions, featuring the new Bosch protection, are now supported in BENCH after Remote Unlock, with your AT Tool.

Bosch MDG1 (VAG)

Our lineup of Bosch MDG1 ECUs is now supported with virtual reading (VR): MD1CP004, MD1CP014, MD1CS004, MD1CS014, MG1CS001, MG1CS002, MG1CS008, MG1CS011, MG1CS111, MG1CP007, MG1CS047.

Continental Getrag DC4 – Renault EDC

You can now operate on Continental Getrag DC4 TCUs found in Renault, directly through the diagnostic port.

Flex OBD for Bosch MD1CS025 and MD1CP006

New version of Flex, version 7.35.0.0, enabling OBD programming for Bosch MD1CS025 and MD1CP006 control units installed on Ford 1.5L EcoBlue Diesel and 6.7L Power Stroke Diesel engines.

New protocol for Delphi CP2.15 – Mercedes-Benz EQx

Work in BOOT mode on the new ECU for EVs, now supported

Yamaha Denso RH850/SH7058

The Denso RH850 and SH7058 ECUs found in Yamaha models are now supported with VR reading via OBD, using your AT Tool.

Kawasaki Denso SH7058 and Mitsubishi MH8115F/MH8610F

Kawasaki is joining the race! The Denso SH7058 as well as Mitsubishi MH8115F and MH8610F ECUs are now supported with VR reading via OBD.

Bosch MDG1 for Ford USA

Version 7.34.0.0 of Flex out now, introducing OBD programming for a wide range of Bosch control units installed on Ford USA vehicles: MG1CS060, MG1CS055, MG1CS040, and MD1CP062.